Back to Contents Page

Specifications: Broadcom NetXtreme™ Ethernet Controller User's Guide

This chapter provides the following information:

10/100/1000BASE-T Cable Specifications

Performance Specifications

Environmental Specifications


10/100/1000BASE-T Cable Specifications

Port Type Connector Media Maximum Distance
10BASE-T RJ-45 Cat. 3, 4, or 5 UTP 100 meters (328 feet)
100/1000BASE-T RJ-45 Cat. 5 UTP 100 meters (328 feet)

 

NOTE: 1000BASE-T signaling requires four twisted pairs of Category 5 balanced cabling, as specified
in ISO/IEC 11801:1995 and ANSI/EIA/TIA-568-A (1995) and tested for additional performance using
testing procedures defined in TIA/EIA TSB95.

 

 


Back to Top


Performance Specifications

This following table lists specifications for single-port Broadcom Controllers:

Feature Specification
PCI Data/Address 32-bit
PCI data burst transfer rate 132 MB/second (32-bit bus)
264 MB/second (64-bit bus)
528 MB/second (64-bit bus at 66 MHz)
PCI modes Master/slave
10/100/1000BASE-T 10/100/1000 Mbps (full duplex)


Back to Top


Environmental Specifications

Condition Operating Specification Storage Specification
Temperature 0°C to 55°C (+32°F to +131°F) -40°C to +85°C (-40°F to +185°F)
Relative humidity 5% to 85% (non-condensing)
40°C, 16 hour dwells at extremes
5% to 95% (non-condensing)
10°C/hour
Altitude Up to 10,000 ft. Up to 35,000 ft.
Shock 10g, 1/2 sine wave, 11 msec 60g, 1/2 sine wave, 11 msec
Vibration, peak-to-peak displacement 0.005 in. max (5 to 32 Hz) 0.1 in. max (5 to 17 Hz)
Vibration, peak acceleration 0.25g (5 to 500 Hz)
(Sweep Rate = 1 octave/min.)
0.25g (5 to 500 Hz)
(Sweep Rate = 1 octave/min.)


Back to Top

Back to Contents Page


Please read all restrictions and disclaimers.